Sun Microsystems X1150A - page 40

18 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • February 2003
4. View the.properties file for a list of device properties.
It might be difficult to tell if the devices on your network are GigaSwift Ethernet
devices or other network interface cards. The.properties command displays the
specific information about the installed adapter.
At the ok prompt,use the .properties command to make sure that the device you
just installed is connected to the network. Youroutput may look different from the
following example:
ok .properties
assigned-addresses 82002010 00000000 01000000 00000000 00200000
82002030 00000000 01200000 00000000 00100000
d-fru-len 00 00 00 00
d-fru-off 00 00 e8 00
d-fru-dev eeprom
s-fru-len 00 00 08 00
s-fru-off 00 00 e0 00
s-fru-dev eeprom
compatible 70 63 69 31 30 38 65 2c 61 62 62 61 2e 31 31 00
reg 00002000 00000000 00000000 00000000 00000000
02002010 00000000 00000000 00000000 00200000
02002030 00000000 00000000 00000000 00100000
address-bits 00 00 00 30
max-frame-size 00 00 40 00
network-interface-type ethernet
device_type network
name network
local-mac-address 08 00 20 aa bb cc
version Sun PCI Gigaswift 1000Base-T FCode 2.11 02/09/23
phy-type mif
board-model 501-5525
model SUNW,pci-ce
fcode-rom-offset 00000000
66mhz-capable
fast-back-to-back
devsel-speed 00000002
class-code 00020000
interrupts 00000001
00000002
00000003
00000004
max-latency 00000040
min-grant 00000040
revision-id 00000011
device-id 0000abba
vendor-id 0000108e