Sun Microsystems X1150A manual List the network devices on your system, Ok show-nets

2.List the network devices on your system.

ok show-nets

Use the show-netscommand to list the system devices. You should see the full path name of the network devices, similar to the Ultra 30 system example below. In this example, the network@4 device is the Sun GigaSwift Ethernet adapter and the network@1,1 is the onboard Ethernet device.

ok show-nets

a)/pci@1f,2000/pci@1/network@4

b)/pci@1f,4000/network@1,1

q) NO SELECTION

Enter Selection, q to quit: q

Note –If you do not see the device listed, check that the adapter is properly seated and, if necessary, reinstall the adapter.

3.View the device that you installed. Using the previous example, type:

ok cd /pci@1f,0/pci@1/network@4

Be sure to write down your device path, which in the example is /pci@1f,0/pci@1/network@4. While your device path may be different, it will be similar. You will need this information to make changes to the ce.conf file. See “Setting Parameters Using the ce.conf File” on page 51.

Chapter 2 Installing the Adapter 17