Chapter 2 Installing the Adapter 21
Installing the Adapter With DynamicReconfiguration
If you have a Sun Enterprise system that supports dynamic reconfiguration (DR),
you do not have to reboot your system after installing the adapter.
The process of adding and configuring an adapter with DR involves (1) connecting
the attachment point and (2) configuring its occupant. In most cases, the
cfgadm(1M) command can perform both steps at once.

▼To Install an Adapter in a Dynamic

Reconfiguration System

1. Verify that the selected board slot is ready for the adapter.
The states and conditions should be:
Or:
#cfgadm
Receptacle state—Empty
Occupant state—Unconfigured
Condition—Unknown
Receptacle state—Disconnected
Occupant state—Unconfigured
Condition—Unknown