Sunbeam LC6200 manual Fitting/using the tools on your MultiProcessor continued, Whisk Attachment

Fitting/using the tools on your MultiProcessor continued

Note: For added safety we recommend that you always leave the food pusher in place whilst operating the processor.

Whisk Attachment

1.Fit the processor bowl and spindle as detailed previously in Figures 2, 3 & 6.

2.Fit the whisk attachment over the spindle and press firmly into place, see Figure 10.

whisk

spindle

Fig 10

3.Add ingredients into the processing bowl.

4.Fit the processing cover to the processing bowl in Figures 4 & 5 and place the food pusher in the feed tube.

5.Plug the power cord into a 230-240V AC power outlet and turn the power ‘ON’.

6.Select the required speed.

7.When processing is complete, remove the spindle and whisk from the processing bowl before removing the processed food.

Slicing, Chipping, Grating and Shredding Blades

1.Place the blade of your choice into the blade holding disc. Hold the blade by the holding clip and insert the other end into the blade holding disc. Press down on the end of the blade with the holding clip until the blade is sitting flat in the blade holding disc, see Figures 11 & 12.

Fig 11

Fig 12

2.Fit the processor bowl and spindle as detailed previously, in Figures 2, 3 & 6.

3.Fit the blade holding disc over the spindle and press firmly into place, see Figure 13.

blade
holding	spindle
disc
Fig 13	LC6200
	Pictured

Warning: Use extreme caution as the blades are sharp.

4.Fit the processing cover to the processing bowl in Figures 4 & 5 and place the food pusher in the feed tube.

13