CLEARANCES |
| NOTE: | ELEC / ELEC Models: Units and ductwork are | |
|
|
| approved for zero clearance to combustible material | |
LOCATION | CLEARANCE |
| ||
when equipped with electric heaters. | ||||
Front | 914 / 36” | |||
| ||||
Rear | 610 / 24” (Less Economizer) |
| GAS / ELEC Models: A 25mm/1” clearance must be | |
1245 / 49” (With Economizer) | ||||
| provided between any combustible material and the | |||
|
|
| ||
Left Side (Filter Access) | 610 / 24” (Less Economizer) | |||
supply air ductwork for a distance of .9 meter/3 feet | ||||
1372 / 54” (With Economizer)3 | ||||
|
|
| from the unit. | |
Right Side (Cond. Coil) | 914 / 36” |
| ||
| ||||
Below Unit1 | 0 / 0” |
| The products of combustion must not be allowed to | |
| 1829 / 72” With 914 / 36” | |||
Above Unit2 | accumulate within a confined space and recirculate. | |||
Maximum Horizontal Overhang | ||||
| ||||
| (For Condenser Air Discharge) | Locate unit so that the vent air outlet hood is at | ||
|
|
| ||
1. Units may be installed on combustible floors made from wood | ||||
least: | ||||
or class A, B, or C roof covering material. |
|
2.Units must be installed outdoors. Overhanging structures or shrubs should not obstruct condenser air discharge outlet.
3.If economizer is factory installed, the unassembled rain hood must be removed from its ride along position in front of evapo- rator coil, or in the outdoor air compartment, prior to final instal- lation.
•9 meters/3 feet above any force air inlet located within 3.0 meters/10 horizontal feet (excluding those integral to the unit).
•1.2 meters/4 feet below, four horizontal feet from, or one foot above any door or gravity air inlet into the building.
|
| ECONOMIZER | |
|
| MOTORIZED | |
SUPPLY AIR | POWER EXHAUST | DAMPER | |
RAIN HOOD | RAIN HOOD | ||
COMPARTMENT | |||
(on Return Air Compartment) | (on Outdoor Air Compartment) | ||
|
930
127 (5”)
•1.2 meters/4 feet from electric and gas meters, regulators and relief equipment.
ECONOMIZER / MOTORIZED DAMPER
AND POWER EXHAUST RAIN HOODS
FIXED OUTDOOR AIR INTAKE HOOD (located on Return Air Compartment)
410 | 25 (1“) CONDENSATE | |
DRAIN | ||
(Must be trapped) | ||
|
716 | 2337 |
(92”) |
REAR VIEW | LH VIEW |
DETAIL “Y”
UNIT WITH RAIN HOODS
FIGURE 15 - UNIT CLEARANCES AND RAIN HOOD DIMENSIONS (15, 20 & 25 TON)
Johnson Controls Unitary Products | 25 |