Chapter 6: Advanced Chassis Setup
6-5 Power Supply
The
In the event that the power supply unit fails, the system will shut down and you will need to change the power supply unit. New units can be ordered directly from Supermicro (see contact information in the Preface).
Replacing the Power Supply (Figure 6-5)
1.Power down the system and unplug the AC power cord.
2.Disconnect all wiring from the power supply.
3.Remove the four screws that secure the power supply to the chassis and extend upwards through the mounting thru holes, to hold the power supply in place (two mounting screws are located on the rear of the power supply and two mounting screws are accessed on the underside of the chassis). Set the screws aside for later use.
4.Remove the power supply from the chassis.
5.Align the mounting thru holes on the power supply with the mounting holes in the chassis and reattach the power supply to the chassis using the four screws which were previously set aside
6.Connect the chassis wiring to the power supply.
7.Replace the top cover, reattach the AC power cord and power up the system.
