Suunto D6I manual Transmitting data, Display Indication

5.8.3. Transmitting data

After the pairing procedure, the Suunto D6i will receive cylinder pressure data from the transmitter. The pressure is displayed in either bars or psi, depending on the unit selected. Any time the Suunto D6i receives an appropriate signal, a flash symbol is displayed in the lower left corner.

Table 5.4. Pressure transmission related displays
Display	Indication	Figure
Cd:--	Set Code. No code stored, Suunto D6i ready for pairing with	A
	transmitter.

Cd:10

- - -

no conn

batt

Set Code. Code number can be between 01–32.

Pressure reading over 360 bar/5220 psi.

Pressure reading has not been updated for more than one minute. The latest valid pressure reading is displayed intermittently. Transmitter is out of range, in power saving mode or on another channel. Activate the transmitter by breathing off the regulator, and assign a new code to the Suunto D6i unit if necessary.

Pressure transmitter battery voltage is low. The pressure reading is displayed intermittently. Change the transmitter battery!

B

C

D

E

48