Suunto D6I manual Diving in the Gauge mode Dive Gauge

NOTE

NOTE

Mix number, O2% and PO2 for the mixes are shown when scrolling. If the set PO2 limit is exceeded , it will be shown with the PO2 value blinking. The dive computer does not allow you to change to a gas whose set PO2 is exceeded. In such a case, the mix is shown but cannot be selected.

If no button is pressed in 15 seconds, the dive computer will go back to the dive display without changing the gas mix. Upon as- cent, the computer prompts you to change gas when the PO2 level you have set for the next mix allows a gas change. The prompt is a low priority alarm followed by the "Change gas" beep, sounded once. The Gas mix (O2%) value blinks.

6.3. Diving in the GAUGE mode (DIVE Gauge)

If set to the GAUGE mode, the dive computer can be used as a bottom timer.

In the GAUGE mode, the total dive time is always displayed in minutes in the lower right corner. In addition, a Dive Timer in the center window displays time in minutes and seconds. The center window Dive Timer is activated at the start of the dive and it can be reset during the dive and used as a stopwatch by pressing the SELECT button.

85