T+A Elektroakustik K1 AV user manual F6 Remote Control Handset, Replacing the batteries

F6 Remote Control Handset

Replacing the batteries:

To open the battery compartment cover release the latch by pressing it in and raising the end. Fit new dry batteries of the LR 03 (MICRO) type, taking care to position them with correct polarity as shown by the engraved markings. Please remember that all the cells must be replaced at the same time.

If you have already switched the remote control to Address 2, you will need to repeat the procedure after changing the batteries (see Chapter 'Changing the remote control address').

Disposal of exhausted batteries:

Used batteries must not be discarded in the household waste! In accordance with the Battery Disposal Regulation (BattVO) they must be returned to the retailer (shop) or to your local toxic waste collection point, where they will be destroyed or recycled safely. All local authorities are now obliged to provide such collection points, and / or vehicles for collecting exhausted batteries.

Switching the remote control address

In rare cases you may find that other remote-controlled equipment in your household uses the same infra-red control codes as the K1 AV. This problem manifests itself in the wrong piece of equipment responding to commands, and carrying out unwanted actions. The K1 AV can be switched to a different remote control address to eliminate such problems.

K1 AV - setting the remote control address:

Switch the machine on and - while the loudspeaker symbols are still flashing - hold the  button pressed in until a running script appears on the integral screen.

When the running script stops, immediately hold the

button pressed in for about two seconds.

This action switches the machine to the alternative remote control address, and displays the new address ‘RC-ADR 1’ or ‘RC-ADR 2’ on the screen.

F6 - setting the remote control address:

Now you have to set the address of the F6 remote control handset to match that of the K1 AV:

Hold the vbutton and the numeric button ó pressed in simultaneously. After about ten seconds the LED on the handset will flash. Now press the numeric button ñor ò, as required.

Pressing the numeric button ñ sets the remote control handset to the standard remote control address (RC-ADR 1), while the numeric button ò sets the alternative address (RC-ADR 2). The LED now goes out to indicate that the change has taken place.

: IMPORTANTThe K1 AV and F6 must always be set to the same address!

45