Problem: | Unwanted whistling sound from the |
| loudspeakers. |
Cause: | The aerial is too close to a mains cable or |
| Cinch |
Remedy: | |
| away. Use an external aerial or a cable |
| connection. |
|
|
Problem: | The K1 AV responds correctly when the |
| front panel buttons are operated |
| manually, but does not react to remote |
| control commands. |
Cause 1: | Incorrectly inserted batteries or flat |
| batteries in the remote control handset. |
Remedy: | |
| ones. |
Cause 2: | No visual contact between the remote |
| control transmitter and the K1 AV’s remote |
| control receiver. |
Remedy: | Ensure direct |
| remote control transmitter and receiver. Note |
| that glass doors may prevent the system |
| working properly. |
| Maximum range between transmitter and |
| receiver is approx. 6 metres. |
| Position the receiver in such a way that it is |
| not subjected to direct sunlight or strong |
| artificial lighting. |
| If you are using a supplementary remote |
| control receiver, this must also be set up in |
| a shaded position. |
| Fluorescent and |
| powerful sources of interference. |
Cause 3: | You are using the incorrect version of the |
| optional E2000 remote control receiver. |
| The correct receiver features two visible |
| |
|
|
Remedy: | Ask your specialist dealer for advice. |
|
|
Cause 4: | The batteries in the remote control handset |
| have run flat, and the remote control |
| address has reverted to the default setting. |
|
|
Remedy: | Change the remote control address of the |
| F6 handset. |
|
|
Problem: | TUNER, CD player or recorder do not |
| respond to control commands. |
Cause: | The machine you wish to operate is not |
| selected as the current listening source. |
Remedy: | Press the corresponding source button on |
| the remote control handset, and try again. |
|
|
Problem: | External devices |
| set, video recorder or similar) respond |
| to the signals from the F6 remote |
| control handset; alternatively the K1 AV |
| responds to remote control signals from |
| external devices. |
Cause: | Only a limited number of remote control |
| codes are available, so it can occasionally |
| occur that systems respond incorrectly in |
| this way. |
Remedy: | The F6 remote control handset and the |
| K1 AV can be set to an alternative remote |
| control address. See the chapter 'Basic |
| settings / Installation / Using the K1 AV for |
| the first time, Switching the remote |
| control address'). |
|
|
53