52
Problem: If the SADV 1245 R is connected to a
TV set directly using a SCART lead,
this can result in a scrolling DVD
picture appearing on all programme
memories. This problem may occur
with many types of TV.
Cause: The TV set is analysing the A/V switching
signal from the DVD player incorrectly, or
not at all.
Remedy 1: I f possible, call up the Setup menu for
your TV set and switch off RGB priority.
Select the RGB signal type for the DVD
SCART input of your TV set.
Remedy 2: I f your television does not provide this
option, connect the DVD player using an
S-VHS lead, or use a SCART lead without
RGB signal. Ask your dealer for help
with this.
Remedy 3: W hen watching TV, switch off the DVD
player by pressing the
button on
the front panel.
Problem: When used in a non- system the
machine does no t respond to remote
control commands, or cannot be
switched on by remote control.
Cause: E 2000 remote con trol receiver not con-
nected.
Remedy: Connect the E 2000 remote control
receiver as shown in Wiring Diagram 3.
Press the source select button
(or
) on the remote control handset
to switch the machine on.
Problem: When operating the menu for the surround
decoder or surround receiver, the
SADV 1245 R also responds.
Cause: E 2000 connected to the SADV 1245 R.
Remedy: Connect the E 2000 to the pre-amplifier,
integrated amplifier or receiver.
Problem: MP3 CD does not play back.
Cause: MP3 format not supported
(see 'Playing MP3 CDs').
Remedy: (see 'Playing MP3 CDs')
Problem: Distorted or double picture at the YUV
output
Cause: P-Scan switched on buit TV set not
compatible with progressive video signals
Remedy: Switch P-Scan off (
button on the
front panel).
Problem: No picture.
Cause: Video-output switched off
Remedy: switch ON the video output (
button on the front panel)
Problem: Bad or distorted sound reproduction
Cause 1: Multi channel mode is selected but only a
stereo amplifier is connected
Remedy: switch to STEREO in the menu
'Preference / Sound / Analog output'
Cause 2: a multi channel amplifier is used but it is
switched to STEREO operation mode
Remedy: switch the surround-amplifier to multi
channel mode
Problem: '
overheatoverheatoverheatoverheat
' displayed, playback stopped
Cause: Device is over heated, too little flow of
cooling air
Remedy: change the installation of your system to
provide sufficient cooling.
do not place the SADV 1245 R on t op of
hot equipment like amplifiers or surround
receivers
Problem: Not possible to switch to MCH mode
Cause: Disc does not contain a m ulti channel
layer
Remedy: no remedy, disc can only be played back
in Stereo.
Problem: The 'WIDE'-mode can not be selected
Cause: switch 'WIDE' at the back panel is set
position 'Disable'.
Remedy: Set switch to position 'Enable'.
Problem: Discs can not be played. A message to
enter a PIN appears.
Cause: This disc is locked
Remedy: Enter a valid PIN number or unlock the
disc (see menu 'Setup / Access').
Note: In case you have forgo tten your PIN
number, enter the menu 'Setup / Access /
Enter PIN'. Enter the input box on the
right and press the
-button four
times (the on screen display will show the
“forbidden” icon). Then enter 0000 twice.
The PIN is now reset to to 0000.