TacT Audio M/S 2150 Connections Biamping - continued, M2150 & S2150, Configurations

M/S 2150 Connections

Biamping - continued

When two or more 2150 amplifiers are configured in a bi-/tri-amped setup, both the signal and the RS232 TacT System Bus must be daisy chained between the amplifi- ers.

The same signal flow is applicable for both horizontal and vertical bi-amping.

From source	From RCS2.0S, RCS2.2X or
Digital signal	TCS mkII *Optional
(coax/SPDIF)	RS232
	AMP-1

Digital signal
(coax/SPDIF)	RS232

AMP-2

Digital signal	RS232
(coax/SPDIF)

AMP-3 - ONLY PRESENT IN TRI-AMPED SETUP

M2150 & S2150	With its advanced DSP control, the M/S 2150 can enable digital crossovers
Configurations	(high-and low-pass) making it is possible to configure the 2150 amplifiers to
	virtually any system.
	Examples of how a TacT active system can be configured:
	1) Active two-way.The M2150 operates as master amp (control unit) and the
	S2150 operates as slave amp. M2150 has a DSP-based high-pass filter and
	drives the high-section of the 2-way loudspeaker. S2150 has a low-pass filter and
	drives the bass-section.
	2) Active three-way.The Tact RCS operates as master pre-amp and the three
	S2150 operates as slave amps. The top S2150 has a DSP-controlled high-pass
	filter and drives the tweeter section. The middle S2150 has a High- and low-pass
	filter and drives the midrange section. The bottom S2150 has a low-pass filter
	and drives the bass section.
14 Tact Audio