Talkswitch E3 manual Incoming, Phone Lines, Line Splitter Extensions 111, To Tel. Line L2

Incoming	TalkSwitch Jacks
Phone Lines
		E1 E2 E3 E4

Line Splitter

Extensions 111 and 112

C O N N E C T I N G P H O N E S , F A X E S A N D D E V I C E S T O T A L K S W I T C H

CONNECTING PHONES: TWO LINE PHONE - OPTION 2

Call Handling:

TalkSwitch extensions 111 and 112 are wired to a two line phone using a line splitter. When a call is transferred to extension 111, line 1 on the phone will show as active; similarly calls on extension 112 will show line 2 as active.

Through the software, you may configure each incoming line to ring any given number of extensions, including all extensions. However, be careful if incoming line 1 is con- figured to ring both extensions 111 and 112. An incoming call will ring both phone lines at the same time. Instead configure incoming line 1 to ring extension 111, and line 2 to ring extensions 112.

To Tel. Line L1 or L1/L2

Line Splitter

Ext 111

To Jack E1

Ext 112

To Jack E2

Connect the male end of the line splitter into the telephone jack labeled “L1/L2”

To Tel. Line L2

Line Splitter

L1 and L2 are single line (2 pin) female connectors that join to a two line (4 pin) male connector. A 4 pin female receptical will indicate that you have a duplexer and not a line splitter.

Male (4 pin)

L1 (2 pin) L2 (2 pin)

Each phone line is connected to the line splitter via a single line RJ-11 cable. The jacks at the end of the cables should have two pins.

Single Line RJ-11 Jack

W W W.T A L K S W I T C H . C O M 6