Tanaka TED-270PFR/PFRS, TED-270PFDLS 5B, TED-270PFL/270PFLS/ 270PFDH/270PFDLS, 5C, GB-8

TED-270

Fig. 2-5 Fig. 2-5B

TED-270PFL/270PFLS/ 270PFDH/270PFDLS

Fig. 2-5C Fig. 2-5D

Drilling (Fig. 2-5, 5B)

Always hold unit firmly with both hands on handles and body well balanced.

Operate at a high engine speed and let drill bit do the work. Do not force bit into hole.

If material become twisted around drill bit, stop engine, allow unit to cool and remove wire from spark plug before attempting to clear bit.

Stop engine and inspect unit if abnormal vibration or noise is generated.

How to operate Lock control

(on TED270PFL/270PFLS/270PFDH/ 270PFDLS) (Fig. 2-5C)

NOTE!

Always stop the engine before operation of lock contorol.

When bit has stuck in object, stop engine and turn on lock lever (1).

Rotate whole unit counter-clockwise so that the bit can be pulled out easily.

If the unit would not move, rotate it clockwise a little and then counter- clockwise again.

How to operate Reverse control (on TED-270PFR/270PFRS) (Fig. 2-5D)

Decrease engine speed to idle and move shift lever (2) to R (Reverse) position, then accelerate to pull out.

Shift lever may not move unless engine is running. If so, turn drill chuck a little bit by hand.

*The purpose of Lock control and Reverse control is mainly for easy pullout of bit.

GB-8