22 Models H71 & H84Operating Procedures
Section 6 Operating Procedures
The “Operator Parts Identification” section in this
manual has been included to identify components
referenced in these instructions. If this is the first time
you have read these procedures, please turn to the
“Operator Parts Identification” section, and familiarize
yourself with these components before proceeding
with the instructions.
Each unit stores mix in a hopper. The mix then flows
through a mix feed tube down into the freezing
cylinder. They both have 3.4 quart (3.2 liter) capacity
freezing cylinders and 20 quart (18.9 liter) mix
hoppers;one each f ort he ModelH71 and two each for
the Model H84.
Duplicate,where t hey apply,the f ollowing steps for the
two freezing cylinders on the Model H84.
We begin our instructions at the point where we enter
the store in the morning and find the parts
disassembled and laid out to air dry from the previous
night’s cleaning.
The following procedures will show you how to
assemblethe part s into the freezer, sanitize them, and
primethe fr eezer with fresh mix in preparation to serve
your first product.
If youare disassembling the machine for the first time
or need information to get to this starting point in our
instructions, turn to page 32 “Disassembly”, andst art
there.

Assembly

Note: When lubricating parts, use an approved food
grade lubricant (Example: Taylor Lube HP).
MAKE SURE POWER SWITCH IS IN THE
“OFF” POSITION! Failure to follow this instruction
may result in severe personal injury from hazardous
moving parts.
Be certain your hands are sanitized before
assembling the freezer.
Step 1
Lubricate the groove and shaft portion that come in
contactwith t he bearing on the beater drive shaft. Slide
the seal over the shaft and groove until it snaps into
place.DO NOT lubricatethe hex end of the drive shaft.
Fill the inside portion of the seal with 1/4” more
lubricant. Lubricate the flat side of the seal that comes
in contact with the bearing.
Figure 1
Note: Make sure the seal is not installed inside-out .
Theridge that prot rudes in the center of the seal should
be on the outside.
Figure 2