3
Models H71 & H84 Safety
050816
Section 3 Safety
Weat Taylor Company are concerned about thesafety
of the operator when he or she comes in contact with
the freezer and its parts. Taylor has gone to extreme
efforts to design and manufacture built-in safety
featuresto prot ect both you and the service technician.
As an example, warning labels have been attached to
thefreezer to f urther point out safety precautions tothe
operator.
IMPORTANT -- Failure to adhere to the
following safety precaution s mayresul t in severe
personal injury or death. Failure to comply with
these warnings may damage the machine and it s
components. Component damage will result in
part replacement expense and service repair
expense.

To OperateSafely:

DO NOT operate the freezer without reading
thisoperator ’s manual. Failure to follow this instruction
may result in equipment damage, poor freezer
performance, health hazards, or personal injury.
SDO NOT operate the freezer unless it is
properly grounded.
SDO NOT operate the freezer with larger
fuses than specified on the freezer data
label.
SDO NOT attempt any repairs unless the
main power supply to the freezer has been
disconnected.
Failure to follow these instructions may result in
electrocution. Contact your local authorized Taylor
Distributor for service.
DO NOT use a water jet to clean or rinse the
freezer. Failure to follow this instruction may r esult in
serious electrical shock.
SDO NOT allow untrained personnel to
operate this machine.
SDO NOT operate the freezer unless all
service panels and access doors are
restrainedwith screws.
SDO NOT remove the door, beater, scraper
blades, or drive shaft unless the power
switch is in the OFF position.
Failureto follow thes e instructions may result in severe
personal injury from hazardous moving parts.
SDO NOT put objects or fingers in door
spout.
SUSE EXTREME CAUTION when removing
the beater assembly.
Failure to follow these instructions may result in
contaminated product or personal injury from blade
contact.
DONOT draw product duringthe HEATcycle
because of high product temperatures.
This freezer must be placed on a level
surface.F ailure to comply may result in personal injury
or equipment damage.
DO NOT obstruct air intake and discharge openings:
3”(76 mm) m inimum air space around all sides. Install
thedeflec tor provided to prevent recirculation of warm
air. Failure to follow this instruction may cause poor
freezer performance and damage to the machine.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the machine and at a height
of 1.6 meters from the floor.