Teac A-R610 Remote Control Unit, ARemote Sensor, Bpower, Cstandby/On, Dinput Selector, Fmuting

ARemote Sensor

When operating the remote control unit, point it towards the

REMOTE SENSOR.

BPOWER

Press this switch to turn the unit standby or off.

The equipment draws nominal non-operating power from the AC outlet with its POWER switch in the OFF position.

CSTANDBY/ON

When the power switch of the main unit is depressed, use this button to turn the unit on or standby.

The standby indicator lights when the unit is in the standby mode. When the unit is turned on, it goes off.

DINPUT SELECTOR

Use this knob (or buttons of the remote control unit) to select a source.

One of the indicaotrs lights to show the selected source.

ETAPE 2 MONITOR

When a cassette tape deck is connected to the TAPE 2 jacks, use this button to turn on or off the tape monitor function. The indicator lights when the tape monitor function is on.

FMUTING

Use this button to mute the sound. This indicator blinks during the muting.

GVOLUME

Turn this knob (or press the VOLUME buttons of the remote control unit) to adjust the volume.

HMIC Jack and MIC LEVEL knob

With the microphone plugged into this jack, the sound picked up from the microphone will be heard together with the source sound selected by the INPUT SELECTOR.

Turn the MIC LEVEL knob to adjust the input level of the microphone.

ILOUDNESS

Use this button to compensate for the loss of bass at low volumes.

JBALANCE

Use this knob to adjust the balance of the speakers. Normally, set the knob to the center position.

KSOURCE DIRECT

Press this button to turn on or off the source direct function. When the source direct function is set to on, the button lights and you can listen to the sound without tone effects.

LTREBLE

Use this knob to adjust the level of high frequency information.

MBASS

Use this knob to adjust the level of low frequency information.

NSPEAKERS buttons

Use these buttons to turn on or off the speakers. on : Sound is output from the speakers.

off : No sound is output from the speakers.

OPHONES jack

For private listening, insert the headphones plug into this jack, and adjust the volume by turning the VOLUME knob.

Remote Control Unit

aON

When the POWER switch of the main unit is depressed, use this button to turn the unit on.

bSTANDBY

When the POWER switch of the main unit is depressed, use this button to turn the unit standby.

cButtons for the operation of TEAC’s CD player

dButtons for the operation of TEAC’s cassette tape deck Use these buttons to operate TEAC components with mark.

eButtons for the operation of TEAC T-R610 (TUNER).

Numeric buttons:

Use these buttons to select a preset channel.

Note:

<To simplify explanations, instructions in this manual refer to the names of the buttons and controls on the front panel only. Associated controls on the remote control will also operate similarly.

ENGLISH

7