Teac A-R610 ASpeaker Connections, How to connect, BAUDIO IN/OUT jacks, DAC Outlet switched

ASpeaker Connections

Caution:

To avoid damaging the speakers with a sudden high-level signal, be sure to switch the power off before connecting the speakers.

<Check the impedance of your speakers. Connect speaker with an impedance of 4 to 16 ohms when using only one pair of speakers (SPEAKERS A or SPEAKERS B). When using two pairs of speakers simultaneously, the impedance should be 8 to 16 ohms.

<The black speaker terminals are _ (negative).

Generally, the + side of the speaker cable is marked to make it distinguishable from the _ side of the cable. Connect this marked side to the + terminal and the unmarked side to the black _ terminal.

<Prepare the speaker cables for connection by stripping off approximately 10 mm or less of the outer insulation. (Removing too much insulation may lead to a short circuit if the bared wires should come in contact with each other.) Twist the strands of the stripped wires tightly together:

Caution:

The metal portions of the two separate wires should not touch or an electrical short can occur. Shorted wires can create a fire hazard or induce a failure in your equipment.

How to connect

Speakers A

1.Turn the terminal cap counterclockwise to loosen it. The speaker terminal caps

cannot be fully removed from the base.

2.Insert the wire into the terminal fully and turn the terminal cap clockwise to securely connect it .

Speakers B

Press the lever, insert the wire, then release the lever.

<Make sure none of the wire insulation is under the terminal, only the bare, stripped wire.

<Make sure the wire is fastened firmly by pulling the cable lightly.

BAUDIO IN/OUT jacks

Analog 2-channel audio signal is input or output from these jacks. Connect the component with commercially-available RCA cables.

Make sure to connect:

white plug q white jack (L: left channel)

red plug q red jack (R: right channel)

CPHONO jacks/SIGNAL GND terminal

Connect the turntable’s RCA pin cords to PHONO jacks. Make sure to connect:

white plug q white jack (L: left channel)

red plug q red jack (R: right channel)

Connect the turntable’s ground cord to SIGNAL GND terminal.

DAC Outlet (switched)

This outlet is active only when the unit is on.

Caution:

Make sure that the total power consumption of all equipment connected to the outlet does not exceed 500mA or 100 watts.

EREMOTE CONTROL jacks

If you have TEAC T-R610, connect the REMOTE CONTROL jack (A or B) of each component by the remote control cord (provided with the T-R610).

FPower cord (AC)

Be sure to connect the power cord to an AC outlet which supplies the correct voltage.

Hold the power plug when plugging or unplugging the power cord. Never pull or yank on the power cord.

ENGLISH

5