Tape Monitor Function

If you want to select the source connected to TAPE 2 jacks, press the TAPE 2 MONITOR button to turn the tape monitor function on. The TAPE 2 MONITOR indicator lights.

Press the TAPE MONITOR button again to cancel the tape monitor function.

<When the tape monitor function is on, sources other than TAPE 2 cannot be heard. Be sure to turn the function off while listening to other sources.

5Play the source, and gradually turn up the volume to the required level by turning the VOLUME knob.

Recording

1.Select a source to be recorded by turning the INPUT SELECTOR.

2.Start recording.

<The volume and tone control have no effect on the recording signals.

<If a 3-head cassette tape deck is connected to TAPE 2 (PLAY and REC) jacks, and if the tape monitor function is set to on during recording, you can listen to not the source sound but the sound being recorded. Press the TAPE MONITOR button to turn on or off the tape monitor function.

Selecting the speakers

Press the SPEAKERS button (A or B) to turn the speakers on or off.

Listening through headphones

For private listening, first reduce the volume level on the receiver to minimum. Then insert the plug from your headphones into the PHONES jack, and adjust the volume by turning the VOLUME knob.

If you want to cut off the sound from speakers, press the SPEAKERS button to turn it off.

CAUTION

Always lower the volume level prior to plugging in your headphones. TO AVOID DAMAGING YOUR HEARING - Do not place your headphones on your head until after you have plugged them in.

ENGLISH

9

Page 9
Image 9
Teac A-R610 owner manual Recording, Selecting the speakers, Listening through headphones, Tape Monitor Function