Teac A-R610 owner manual Remote Control Unit, Basic Operation, Battery Installation

Remote Control Unit

The amplifier and some other TEAC components which have mark on the front panel can be operated by the provided “UR” remote control unit.

When operating the remote control unit, point it towards the REMOTE SENSOR on the front panel of the amplifier (or other TEAC component).

<Even if the remote control unit is operated within the effective range, remote control operation may be impossible if there are any obstacles between the unit and the remote control.

<If the remote control unit is operated near other appliances which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the other appliances may operate incorrectly.

Battery Installation

1.Remove the battery compartment cover.

2.Insert two “AAA” (R03 or UM-4) dry batteries. Make sure that the batteries are inserted with their positive “+” and negative “_” poles positioned correctly.

3.Close the cover.

Battery Replacement

If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. In this case replace the batteries with new ones.

Precautions concerning batteries

<Be sure to insert the batteries with correct positive “+” and negative “_” polarities.

<Use batteries of the same type. Never use different types of batteries together.

<Rechargeable and non-rechargeable batteries can be used. Refer to the precautions on their labels.

<When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking. If they leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones.

<Do not heat or disassemble batteries and never dispose of old batteries by throwing them in a fire.

Basic Operation 1

2 4 1 5

3TAPE 2

MONITOR

1To protect speakers from a sudden high-level signal, turn the VOLUME knob counterclockwise to minimize the volume.

(infinity): minimum volume 0dB: maximum volume

2Press the POWER switch.

The unit enters standby mode, and the standby indicator lights.

3Press the STANDBY/ON switch to turn the unit on.

The standby indicator goes off.

4Select a source by turning the INPUT SELECTOR (or pressing one of the input buttons of the remote control unit).

8