Playback
Playback with TAPE I or TAPE Il
1.Press the POWER switch.
2.Set the REV MODE switch to the required tape travel mode.
Ä: One Side Playing
ïË: SideA ∑ SideB ∑ Stop
Ë |
| ä: |
| ∑ SideA ∑ SideB |
|
|
|
|
| ||||
| ||||||
ä |
|
|
|
|
|
|
|
| The tape will stop after 5 cycles. | ||||
Continuous Playback
1. Load
3.Load a
4.Select the appropriate DOLBY NR system.
5.Press the Ó or Á button of TAPE I or II to start playback.
6.Adjust the volume with the amplifier's volume control.
…To stop playback, press the STOP button.
Pitch Control (TAPE I only)
Using the Pitch Control knob, the pitch (tape speed) of TAPE I can be changed.
The center is the normal speed. Turning the knob toward
2.Select the appropriate DOLBY NR system.
3.Set the REV MODE switch to the CONT PLAY (ä) position.
4.Press the Ó or Á button of the deck to be played back first.
5.Tapes will be played back continuously. below;
ENGLISH
ï
Ë
ä
See the chart
compared with the normal speed.
…If a Dolby NR encoded tape is played back with Pitch Control, the sound may not be reproduced properly.
…To stop continuous play before the tapes are played back 5 times, press the STOP button of either deck.
Continuous Playback Operation
| Tape I |
| Tape II |
Side A Start | Side A Start | ||
|
|
|
|
|
|
|
|
|
|
|
|
Side B Start | Side B Start |
1.When playback starts in the forward direction, at the end of Side A, the tape is reversed to play the other side, Side B.
At the end of Side B, TAPE I is released.
If you start playback from Side B, TAPE I is released at the end of Side B.
2.Control is transferred to TAPE Il, and playback starts from Side A.
At the end of Side A, it is reversed and Side B is played back.
3.At the end of Side B of TAPE II, control is transferred back to TAPE l, and the playback of Side A starts.
…TAPE I and II will be played back 5 times in total, then this function will stop.
7
