7 Support
7.2 Using the Wall Mounting Assembly
Wall mounting | Part of the package is a wall mounting assembly which allows you to conveniently mount | |
assembly | the SpeedTouch™ on a wall. | |
| Before you start, check for the following items: | |
| • | The wall mounting assembly (with Velcro sticker and counterpart sticker in place) |
| • | 2 screws and 2 wall plugs |
Preparing and using the |
| |
Proceed as follows: | ||
wall mounting assembly | 1 | Mark two hole horizontal positions, 134 mm (5.36 inches) apart: |
| ||
2Drill the marked holes with a 6mm (0.24 inches) diameter drill bit to a minimum depth of 35mm (1.38 inches).
3Insert the wall plugs in the drilled holes, position the wall fixing assembly over the holes, insert the screws in the wall plugs and tighten them firmly:
4Remove the covering sticker from the (counter) Velcro sticker.
5Position the SpeedTouch™ over the two hooks:
6Slide the SpeedTouch™ down into place and firmly press it to the assembly to stick the counterpart Velcro sticker to the SpeedTouch™ housing.
76 | |
|
