cwmp Commands
100 E-DOC-CTC-20071119-0014 v1.0
cwmp config
Configure the cwmpd as seen from the ACS.
SYNTAX:
cwmp config [state = <{disabled|enabled}]>
[mode = <{read-only|full}]>
[periodicInform = <{disabled|enabled}]>
[periodicInfInt = <number]>
[sessionTimeout = <number]>
[noIpTimeout = <number]>
[maxEnvelopes = <number]>
[connectionRequest = <{disabled|enabled}]>
[connectionReqPath = <string]>
[connectionReqUserName = <quoted string]>
[connectionReqPsswd = <password]>
[connectionReqAuth = <{none|basic|digest}]>
[qos-class = <number]>
[bootdelayrange = <number]>
[upgradedelay = <{disabled|enabled}]>
[am1Termination = <{disabled|enabled}]>
[persistentSubscription = <{disabled|
enabled}]>
where:
state The state of the cwmp daemon. OPTIONAL
mode Set the operation mode of the cwmp daemon. OPTIONAL
periodicInform Set periodicInform flag of the cwmp daemon. OPTIONAL
periodicInfInt Set the interval between two periodicInform
messages in seconds. OPTIONAL
sessionTimeout Set HTTP session-timeout in seconds. OPTIONAL
noIpTimeout Set time (in seconds) ip may be 0 after
uploading new config file. OPTIONAL
maxEnvelopes Set the maximum number of SOAP envelopes
send within one http-message. OPTIONAL
connectionRequest Set connection request flag of the cwmp
daemon. OPTIONAL
connectionReqPath Set the path where the cwmp daemon can be
reached. OPTIONAL
connectionReqUserName Set the username the ACS must use to log in. OPTIONAL
connectionReqPsswd Set the password the ACS must use to log in. OPTIONAL