Tefal GV7085C0, GV7085C1, GV7085CH manual Rinsing the boiler once a month, Storing your generator

Before cleaning, ensure your steam generator is unplugged and that the soleplate and the iron have cooled down.

1800121480 GV7085 E0 GTK _110X154 01/03/11 11:52 PAGE4

Rinsing the boiler (once a month)

• To extend the efficient operating life of your boiler and avoid scale particles on your linen, your generator is equipped with an orange “boiler rinse” warning light that flashes on the control panel after about 10 uses - fig. 9.

• If the orange “boiler rinse” warning light flashes, you can continue ironing normally but remember to rinse the boiler first the next time that you use it.

•Before proceeding, check that the generator is cool and unplugged for more than 2 hours.

•Place the steam generator on the edge of your sink, with the iron placed to one side, standing on its heel.

•Unscrew anti-clockwise a quarter of a turn the boiler rinse cap - fig. 10.

•Using a coin, gently unscrew the boiler rinse cap - fig. 11.

•Holding the steam generator in a tilted position, and using a jug, fill the boiler with ¼ litre of untreated tap water - fig. 12.

•Shake the base unit for a few moments and then empty it completely into your sink - fig. 13.

•To obtain the best results, we recommend that this operation is done twice.

•Screw back and tighten up the boiler rinse cap with a coin.

•Put the boiler rinse cap cover back in place.

•The next time you use the generator hold down the “OK” button for a few seconds to turn off the orange light - fig. 17.

Storing your generator

Caution! Above all, you must not use descaling products to rinse the boiler: they may damage it. Before cleaning or emptying your generator, it is imperative that you leave it to cool for more than 2 hours, to prevent any risk of burns.

•Warning: do not touch the soleplate while still hot.

•Fold the carrying arm down onto the iron until it clicks into position, ensuring that your iron is safely locked onto its housing (depending on model).

•Store the electrical cord in its storage place - fig.7.

•Store the steam cord in the cord storage clip - fig.8.

•Leave the iron (and the iron rest) to cool down for 1 hour before storing it away.

A problem with your generator ?

PROBLEMS	CAUSES	SOLUTIONS
The generator does not come	The appliance is not	Check that your appliance is
on and the thermostat light is	switched on.	correctly plugged in
not illuminated.
Water runs out of the holes in	Water has condensed in the	Press on the steam control
the soleplate.	pipes because you are using	button away from your ironing
	steam for the first time or you	board until the iron produces
	have not used it for some time.	steam.
	The soleplate is not hot	Wait for the thermostat light to
	enough.	go out before activating the
		steam button.
Water streaks appear on the	Your ironing board is saturated	Check that your ironing board
linen.	with water because it is not	is suitable.
	suitable for use with a steam
	generator.

4