TROUBLESHOOTING
Reread the sections of this manual to make sure you have completed system
If you are unable to solve the problem, con- tract the dealer from whom you purchased the system for assistance.
PROBLEM | SOLUTION |
|
|
DISTORTION - System’s audio quality | Reduce microphone gain by adjusting mi- |
seems distorted at medium to high input | crophone gain control. |
levels. |
|
|
|
HISS - System seems to produce a “hiss” | Check the gain setting on all beltpacks and |
which is undesirable. | the base. They may be too low. |
|
|
LOW OUTPUT - System produces a | Check the gain setting on both the beltpacks |
low output level. | and the base. They may be too low. |
|
|
FEEDBACK - Moving around area of | Reduce the gain settings on both the |
use produces “squeal” or “howl” in vari- | beltpacks and the base. They may be too |
ous location using ext. speakers. | high. |
|
|
DROPOUTS - When moving around the | Make sure both antennas on the base are |
area of use there seems to be locations | connected and follow the location sugges- |
where the signal “swooshes” or com- | tions. Change the location of the base unit |
pletely disappears. | and antennas or avoid the bad areas with |
| the remote beltpacks. |
|
|
INTERFERENCE - System picks up | Make sure the |
signals other than wireless Intercoms. | on - this will usually eliminate the interfer- |
| ing signal. If not using a beltpack, make |
| sure the corresponding enable switch at the |
| base is disengaged. |
| If problems persist with the |
| beltpack on, you will probably need to have |
| your system’s frequency changed to an- |
| other channel. |
|
|
NO AUDIO from BASE or BELTPACK | Check Transmitter switch on base, use |
headsets. | CONT or REMOTE position. Check |
| |
|
|
