Example System Configurations | Telex BTR-500/600C specs

Example System Configurations

Single Base Station Audiocom (Telex) System

The audio out RCA jack on the back of this unit is used for the public address system. The unused Audiocom channel must be terminated to avoid loud feedback if audio channel two was switched to by the beltpack.

The audio out of the base station’s RCA jack is the audio channel currently switched to at the BTR-500.

LOUD

SPEAKER

AUDIO CHANNEL 1 = RANGE INSTRUCTIONS AUDIO CHANNEL 2 = NOT USED

LOUD

SPEAKER

TARGET

AREA

SHOOTING

AREA

PA SYSTEM

1 CH

1 CH 1 CH 1 CH 1 CH 1 CH

SHOOTER'S WIRED BELTPACKS

Telex

RANGE DIRECTOR

	AUDIOCOM
	POWER SUPPLY
	TRANSMIT	BTR-500		RECEIVE
			FCC ID. B5DM503	ANT.
BTR-500	ANT.		MADE IN U.S.A.	ANT.
BTR-500			PATENT PENDING
	I/C 1	I/C 2	AUX

TELEX

LOAD

Figure 47

Example single BTR-500 Audiocom System used at a Shooting Range

-25-

Image 28

Telex BTR-500/600C operating instructions Example System Configurations, Single Base Station Audiocom Telex System

Contents

Telex Table of Contents Customer Service Information FCC Information Introduction System FeaturesGeneral Description Base Station Transceiver Front Panel Controls and Connections Intercom 1 and 2 Jacks Switch set to Telex Intercom 1 and 2 Jacks Switch set to RTSBase Station Controls and Connections Rear Panel BTR-600C BTR-500/600C Specifications Auxiliary Jack Beltpack Headset Jack WiringControls and Connections Beltpack Specifications Initial Equipment Set-Up UnpackingAntenna Connection Quantity Descripton Antenna Polarization Antenna PlacementDistance between Antennas Operating System Near Obstructions Distance Between base station BeltpackKeeping Site Clear to Antenna Antenna Placement Improving Reception and Increasing Range RF Transmit/Receive Channel Switches Base Station Set-UpLocation Rack Mounting Intercom Type Switch RF Transmit Mode SwitchDual Listen Switches Audio Channel Switch Telex IN/OUT SwitchAuxiliary to I/C Switch Program Audio Auxiliary Switch Auxiliary to I/C Switch Interconnection to a Hard-Wired Intercom SystemConnecting Base Stations Together Example Interface to an Audiocom Telex Intercom System Intercom User Station US-2000A Program Speakers Intercom Power Supply PS15 Example Interface to an RTS Intercom System Auxiliary Audio Connection Power ConnectionDummy Load Code Switch TR-600C Only Connecting HeadsetRF Channel Switches and RF Transmit Mode Beltpack Set-Up Battery Installation Battery Installation Pre-Walk-Thru Checklist Power Push-to-Talk/Lock-to-Talk SwitchLocal Headset Volume System Operation Dual Listen Level Intercom LevelAuxiliary Level Sidetone Level Power/Local Headset Volume Battery CheckBeltpack Operation Push-to-Talk/Lock-to-Talk Microphone Gain Sidetone Level Control Example System Configurations Single Base Station Audiocom Telex System Curtain Director RTS Power Supply Single Base Station RTS System Six Base Station RTS System Example of Six BTR-500 RTS Systems used by a Production Unit Eight Base Station Telex System = Beltpack Position 1 *2 = Beltpack Position Single Beltpack to Single Beltpack System Beltpack to Beltpack SystemExample of a TR-500 System used at a Publishing Firm System Walk-Thru Troubleshooting Tech Tips Codes Settings and the BTR600CFrequency Interaction Battery Information Intercom Systems Specifications Accessories and Replacement Parts Customer Service Information FCC Information JAN Made in U.S.A