Battery Installation

Insure that the OFF/ON volume control knob is turned OFF. Press down the battery release latch and remove battery pack. Pack slides off in opposite direction. Replace batteries as follows:

1.Open the battery pack by inserting finger nail and lifting as shown.

2. Pull battery strap to remove low or dead batteries.

3.Load new batteries with negative end against the spring.

4.Start loading at hinged end of case.

5. Be sure strap goes under batteries and over the top of the ribs.

6. Tuck end of strap under door when closing.

Figure 36

Battery Installation

-19-

Page 22
Image 22
Telex BTR-500/600C operating instructions Battery Installation