Thermador P30 Grill/Griddle Tilt Adjustment Not All Models, Dolly Positioning

Step 3: Unpacking, Moving and Placing the Range

•Due to the weight, a dolly with soft wheels should be used to move this unit. The weight must be supported uniformly across the bottom (See Fig. 5).

•After transporting the professional range by dolly close to its final location, the range can be tipped back and supported on the rear legs while the dolly is carefully removed. THE FLOOR UNDER

THE LEGS SHOULD BE PROTECTED. BEFORE PUSHING THE UNIT INTO POSI- TION. The anti-tip device must be installed (STEP 4), gas and electrical connections should be made (STEPS 5 and 6), and the backguard installed (STEP 7) before the range is placed in its final position.

•For proper performance, the range must be level. (It is very important for all products that have the griddle feature.) The range is leveled by adjusting the legs with a wrench.

•Replace the kick panel. It is important that the two (2) screws retaining the kick panel are secure to prevent accidental access to hot surfaces.

•Ensure that the burner caps are correctly seated on the burner bases of the range's cooktop.

FIG. 5- Dolly Positioning

Remove all tape and packaging before using the appliance. Destroy the packaging after unpack- ingtheappliance.Neverallowchildrentoplaywith packaging material.

IMPORTANT: DO NOT lift the range by the oven door's handle, as this may damage the door hinges and cause the door to fit incor- rectly to the oven cavity.

Grill/Griddle Tilt Adjustment (Not All Models)

If the range is equipped with an electric griddle or gas grill, check the grill/griddle frame adjustment by pouring two tablespoons of water on the back of the griddle or grill plate. The water should slowly roll into the grease tray. If not, adjust the two screws under the back of the frame. Start with one half turn counterclockwise (CCW) of the screws. Further adjustment should be made by one-quarter turn until water slowly flows into the grease tray.

9