CLEANING YOUR APPLIANCE
Replacing top door trim
•Take hold of the top door trim at each side and position it to the inside edge of the glass.
•Push the trim down with its top edge over glass panel until the clip snaps in on each side of
the trim.
Cleaning the pyrolytic oven door
(POR883 & POR881 modelS only)
Your pyrolytic oven is equipped with an oven door that can be disassembled in order to clean all the panes of glass.
Positioning the door for dismantling
The door needs to be positioned at an angle to aid in the disassembly of the panes.
•Open the oven door fully and flip out the locating tab on each hinge to the open position.
•Gently close the oven door until it stops on the locating tabs. The door is now ready for dismantling.
Removing the top door trim
•Push in the 2 buttons on either side of the trim.
•Lift the trim away from the door.
Removing the glass panes
•Remove the 3 panes of glass starting with pane 1.
•When removing pane 3 ensure that the 2 rubber supports are removed before cleaning. Do not misplace them!
Cleaning the glass panes
Clean with a damp cloth.
Do not use scouring agents or abrasive sponges as these could damage the reflective surface. Dry thoroughly before reassembly.
Replacing the glass panes
•Replace the glass panes back into the door starting with pane 3.
•Ensure this pane is placed into the correct slot and that the 2 rubber supports are in place.
•Next replace pane 2. There is a reflective coating on this pane. This coating is indicated by a circle printed on its surface. Ensure this circle is in the same corner as pictured below.
Circle in this corner |
•Replace pane 1 ensuring the black screening is facing inwards towards the oven.
Replacing the top door trim
Replace the trim ensuring the clips snap into the 2 location holes. Open the oven door fully and return the locating tab on each hinge to the original closed position.
CLEANING | 34 | 35 | CLEANING |
|
|
|
|