Required accessories and tools
1. Supplied accessories
-Installation instructions
-Operating instructions
-Installation kit
2. Optional accessories8.
Basic Combination Side$by$Side Sealing kit
-Cutter with adjustable blade
-Metal tape measure
-Square
- Spirit level length 2' (60 cm) and 4' (1,2 m)
-Markingout level, length at least 4' (1.2 m) for individual appliances or 7' (2.0 m) for SidebySide installation
For | permanent connection of two individual appliances, | |
e. g. | Freezer next to Refrigerator. | 5. Other |
| ||
Extreme Combination Side$by$Side Heating kit
If the | gap | between the | appliances is less | than | |
6" (160 mm). |
|
|
| ||
Extra long finger protection part |
| ||||
Panel | unification | part | (Metal strip) |
| |
For connection of | two furniture doorsCan . be used | ||||
for standard | height | furniture doors without | further | ||
preliminary | work. |
|
|
| |
-Stepladder
-Dolly, hand truck
- Hammer drillfor drilling holes in wall or floor
-Bits according suitable for material and in different sizes
-Wooden beam (cross section min. 3" x 4"
(75 cmx100 cm)) as an alternative tilt protection, length according to the width of the installation cavity
3.Other required accessories from specialist outlets
Ice maker installation kit ¼" OD copper line
- Wooden screws in different sizes
-Thin (max.1/16" (1.5 mm)), suitable material to protect the floor from damage (e.g. lino)
For connecting appliances which require water, e.g. for- an ice maker.
Suitable material for covering and protecting furniture (e.g. protective sheets)
i
Maximum outer diameter of the water pipe | - Adhesive tape | |
| ||
(without fittings): | 13/ " (10 mm). |
|
| 32 |
|
4. Tools
-Cordless screwdriver T20
-Torx screwdriver T20
- Torx bit T20 + magnetic holder
-5/16" (8 mm) hex nut driver
- Wood drills in different sizes
-Open end wrench ½" (SW 13 mm)
-Multigrip pliers
-Adjustable wrench
12
