12.Installing and aligning the cordappliance
qAlign the appliance with the furniture fronts.
Place markingout level over the installation aid parts on the door.
i
The installation aid parts on the door have been designed for the following total thickness of furnitu doors:
-3/4" (19 mm)
-1/2" (38 mm)
Always take account of the possible differing thickness of the furniture fronts which are to be fitted subsequently.
The | heightadjustable feet at the front and rear can a |
be | adjusted from the front. |
Front: with openended wrench1/2" (SW13)
Rear: with 5/16" (8 mm) hex nut driver via flexible shaft.
d CAUTION d
Never use a cordless screwdriver!
A | mark is | attached to the appliance base and is use | |||||
a | standard | gage | for | height | adjustment. | When adjusting | |
the height, | align | this | mark | 1 |
| (32of 1mm) | |
at a height/ " | |||||||
above the | floor. |
|
|
| 4 |
| |
|
|
|
|
|