Tiger 70709 manual Assembly Variations Option connector, Specifications

HARDWARE VARIATIONS

HARDWARE VARIATIONS

Assembly Variations

The Option connector

9-1

Fitting Plastic Leg and Antenna Parts

Antenna
Socket	Leg Housing

Left

Right

The WonderBorg has an Option connector, allowing even more advanced remodeling. The Option connector is on the underside of the WonderBorgrear end, and allows you to connect one external load such as a motor, or one external sensor such as a switch. To use this connector, you will need general knowledge of electrical circuits, a 2.54mm pitch, 4-pin connector (female) Morex type or other connector, and the ability to perform soldering. Care is needed when using the Option Connector: creating an inappropriate connection may damage the WonderBorg circuits.

Caution

Option Connector 2.54mm pitch, 4-pins may have sharp points.

Underside of WonderBorg

Option Connector 2.54mm pitch, 4-pins

Antenna

Leg

Fit the legs on the other side in the same way.

Use these parts if you prefer to make the assembly process as easy as possible.

Note: Turn the power ON before adjusting the angle of the legs.

9-2

Fitting the Tires

Fit each of the legs at the angle shown in the diagram

Specifications

OUTPUT	Supply voltage: 4.5V, maximum supply current: 500mA, ON / OFF only
	Out +: Current output connected to robot’s battery +
	Out -: Open corrector
INPUT	Mechanical electrical contact points (switches, etc) short-circuit resistance:
	1kΩ or lower
	Switch input A: Microcomputer input, pulled high (100kΩ )
	Switch input B: Connects to GND (robot’s battery -)
	This connector allows an additional motor to be added.

Pin Layout and Reference Circuit

Caution

If an inappropriate external circuit is connected to the Option Connector, this may result in damage to either or both the WonderBorg and the external circuit. Only connect an external circuit if you are fully aware of its specifications.

Option Connector

Use a 2.54mm pitch, 4-pin connector such as a Morex.

Leg Housing

Tire

Fit the tires on the other side in the same way.

Rear End of WonderBorg

Output +

Output -

o.1uF

Ceramic condenser

Note: A ceramic condenser must be connected, or else the WonderBorg may malfunction.

Switch input A

Switch input B

Load such as motor

select a load between 3 and 4.5 V, and not more than 500mA (This device can be switched ON for a given period of time using the "Option ON" command.)

Microswitch

19

-Unpressed: reacts to sensor when Option is in State 0

-Pressed: reacts to sensor when Option is in state 1

20