Toshiba 40L3400U, 50L3400U manual FCCDeclarationof Conformify ComplianceStatementPart15

Removing the Pedestal Stand

1)Carefully lay the front of the unit face down on a flat, cushioned surface such as a quilt or blanket. Leave the stand protruding over the edge of the surface.

Note: Extreme care should always be used when removing the pedestal stand to avoid damage to the LCD panel.

2)Remove the stand screws shown in the diagram below.This will allow removal of the pedestal stand.

3)Once you have removed the screws holding the

pedestal stand in place, remove the pedestal stand from the TV.

L3400U Series

40" TV.

VESAMountingPattern

Ih Hook Sturdy strap

Two stand screws (as short as possible) (Sample Illustration)

50" TV.

VESA Mounting Pattern

Two stand screws L Hook Sturdy strap (as short as possible)

(Sample Illustration)

CAUTmON: Always place the TV on the floor or a sturdy, level, stable surface that can support the weight of the unit. To secure the TV, use a sturdy strap from the hook(s) on the rear of the TV to a wall stud, pillar, or other immovable structure. Make sure the strap is tight, secure, and parallel to the floor.

7

FCCDeclarationof Conformify ComplianceStatement(Part15):

Toshiba 40L3400U and 50L3400U Television

models comply with Part 15 of the FCC Rules.

Operation is sut!ject to the ILllowing two conditions:

(1)This device may not cause harmful imerf_rence, and

(2)This device must accept any interference received, including interference that may cause undesired operation. The party responsible tbr compliance to these rules is: Toshiba America Information Systems, Inc.

9740 Irvine Blvd., Ila-ine, CA 92618. Ph: 800-631-3811

Note: This equipment has been tested and found to comply with the limits fore Class B digital device, )ursuant to Part 15 of the FCC Rules. These litnits are

designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a )articular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by removing and applying )ower to the equipment, the user is encouraged to try to correct the interference by one of the following measures.

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radioiTV technician for help.

Caution: Changes or modifications to this equipment

not expressly approved by Toshiba could void the user's authority to operate this equipment.

WirelessRadio

For product available in the USA Canada market, only channel 1-11 can be operated. Selection of other channels is not possible. The device could automatically discontinue transmission in case of absence of inl5rmation to transmit, or operational failure. Note that this is not intended to _rohibit transmission of control or signaling infbrmation or the use of repetitive codes where required by the technology.

The device could automatically discontinue transmission in case of absence ofinl\_rmation to transmit, or operational failure. Note that this is not intended to prohibit transmission of control or signaling infbrmation or the use of repetitive codes where required by the technolog?_ If this device is going to be operated in 5.15-5.25GHz frequency range, then it is restricted to an indoor environment onlv.

Important: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.