18
Do not expose batteries to excessive heat such as sunshine, fire, etc.
Using the remote control
Dispose of batteries in a designated disposal area.
Always consider the environment when disposing of batteries.
Always follow applicable laws and regulations.
If the remote does not operate correctly, or if the operating range is reduced, replace the
batteries.
Always replace both batteries with new ones. Never mix battery types or use new and used
batteries together.
Always remove batteries from the remote if they are dead or if the remote control is not to
be used for an extended period of time.
This prevents battery acid from leaking into the battery compartment.

For optimum performance, aim the remote control directly at the player and make sure there

are no obstructions between the remote control and the player. The maximum operable

ranges from the unit are as follows.

Line of sight: approx. 7 m (original state)

Either side of the centre: approx. 5 m within 30° (original state)

Above: approx. 5 m within 30° (original state)

Below: approx. 5 m within 30° (original state)

(Sample Illustration) Remote control - effective range

Do not expose the remote sensor to a strong light source such as direct sunlight or
other
illumination. This can damage the sensor resulting in the inability to operate the player
via
the remote control.
Do not drop or expose the remote control to electric shock.
Do not expose the remote control excessively hot or humid places to avoid
moisture
condensation.
Do not spill water or place anything wet on the remote control.
Do not open the remote control unit (other than the battery door).
If the remote control is not going to be used for a long period of time, remove the
batteries
to avoid damage caused by battery leakage corrosion.
Direct the remote control at the remote sensor of Blu-ray DiscTM and Online Media Player.
When using the remote control, press the buttons at intervals of approximately 1 second
to
ensure the correct mode of operation.
Assembling the Desktop stand (Optional)
The Desktop stand comes with the Blu-ray Disc
TM and Online Media Player; you may assemble the
Desktop stand before all connections
.
1. Use a screwdriver (not supplied) to unscrew the screws on the rear panel.
2. Insert the two screws that are included with the player through the holes of the Desktop stand.
Align the screw holes on the player with the screws
.
3.
Gently tighten the screws with the screwdriver (not supplied). In order to use the cover of the
Desktop stand slot for the future, please attach it to the bottom of the Desktop stand. Refer to the
following figure for details
.
Using the Remote Control