Toshiba CTX manual Station Call Forward Procedures, To use the Call Forward button sequence

Advanced Operation

Call Forward

•Call Forward Busy/Do Not Disturb/No Answer – Forwards all calls to your station whenever you are busy, in the DND mode, or after ringing and you do not answer the call within a designated time (set by you when you enable the feature).

•Call Forward Cancel – Cancels the set Call Forward feature. Notice that each category of Call Forward has a different code for canceling.

Station Call Forward Procedures

Table 2, “Call Forward Procedure” contains Call Forward Button sequences. You can do a Call Forward function by, one, entering the button sequence as described, or two, by programming a Flexible Button to perform the sequence. See “Programming Feature Buttons” on page 71 for instructions on programming a Flexible Button.

➤To use the Call Forward button sequence

➤Follow the instructions in the following table, shown under “Button Sequence.” Some features require additional input, such as:

•Dest. Ext. or Telephone No. – CF destination numbers can be internal

extension numbers or outside telephone numbers. If the destination is an outside number, enter the access code used for dialing out (such as ￿) + the telephone number + ￿. The CTX accepts destination numbers of up to 32 digits. (See following examples).

•Timer – Enter the number of seconds (08~60) your telephone should ring before forwarding the call. (This is the CF-No Answer timer.)

•CF Pass Code – A four-digit Call Forward (CF) pass code established by system programming is required to allow one station to set CF for another station. This code is also used to allow DISA callers to set CF for another station. Users must enter the CF pass code for the station to be forwarded.

Note In Table 2, (tone) means that confirmation tone (three short tones) will play at that point in the sequence to confirm your input was accepted.

32 Strata CTX DKT/IPT Telephone 11/03