Toshiba CTX manual Manual setting, then press +ROG. Press %

IPT1020-SD Settings

IPT-to-IP Network Connection Instructions

6.If the IPT is connected to a router or other gateway device, press )%￿. Enter the router address, then press +ROG. Only used if Step 3, above, is set for manual setting.

7.Press )%￿. Enter a Station ID for the IPT and press +ROG. This is usually your telephone’s primary number (PDN).

8.Press )%￿ to enter the CTX Strata Net node number of the CTX node that contains the BIPU-M1A to which this IPT interfaces, then press +ROG. This FB setting is for CTX networked systems only.

9.Press )%￿￿ for BIPU IP address mode. Press one of the following:

￿: manual setting, then press +ROG. Press )%￿￿

then press +ROG. (e.g., if the BIPU IP address is format ￿￿￿￿￿￿￿￿￿￿￿￿￿).

￿: auto setting by broadcast, then press +ROG.

and enter the BIPU IP address, “192.168.1.241,” enter it in this

￿: auto setting by multicast (IPT doesn’t support multicast setting in this first release), then press +ROG.

10.Press +ROG again to set all the above data.

11.Go off-hook and hang up. The IPT will search for the BIPU-M1A, initialize and then set the IP address (from 20 sec. to 60 sec.). Time, Date and PDN displays on LCD when the information is set.

Note See “IP Telephone Start Up Sequence” below for an explanation of the LCDs that you will see during this procedure.

Strata CTX DKT/IPT Telephone 11/03 97