Toshiba D-R2SC, D-R2SU, D-KR2SU owner manual 133, DVD recorder operation

DVD recorder operation

AV record quality

DVD-RAM DVD-RW DVD-R

You can select from 5 combined picture and sound quality recording settings prior to actual recording. Actual selection applied becomes the default setting for the normal recording or programmed recording.

e.g.

AV record quality

	DVD	- - -			SP 4.6				D/M1
Custom setting
	Setting		Mode	Rate		Audio quality
1	Manual	6. 6		L-PCM
	2		S P	4. 6				D / M1
	3		L P	2. 2				D / M1
	4		Manual	6. 0				D / M2
	5		Manual	3. 2				D / M1

Total recording time: approx. 122min.

(with 4.7 GB unused)

•To make a combination of picture and sound quality settings.

1)Press the / / / buttons to select the desired item (“Mode”, “Rate”, or “Audio quality”).

2)Press the ADJUST button to change the setting of each item.

•To apply the combination of picture and sound quality settings.

1)Press the ADJUST button to change the setting.

You can confirm the available recording time for the selected setting on the bottom screen.

2)Press the ENTER button.

Notes

•You can change the combination of picture and sound quality settings also by displaying the Quick Menu on a LIBRARY MENU or during stop mode, then selecting “AV record quality”. Either of the above methods updates the setting of this recorder.

•If you set “SP” or “LP”, you cannot select “L-PCM”.

•Depending on the sound quality settings, the upper limit for the picture quality setting differs.

•You can adjust the manual rate for picture quality by

0.2 Mbps from 2.0 to 9.2. (You cannot set the rate from 1.4 to 2.0.)

Picture record mode

DVD-RAM DVD-RW DVD-R

Adjusts problems with the brightness of video signals of TV broadcasts or other external input.

(Only use this setting when you cannot adjust the brightness satisfactorily with the Custom picture setting in the Picture/Audio settings ( Page 129) of this recorder.)

Important:

•This setting changes the video signal to record and the recorded signal is not returned to the original state even when this setting is changed after recording. When duplicating from VHS tape, if you can check the video recording state beforehand, we recommend first playing back for a while and checking the overall brightness tendency, then setting an appropriate mode.

Standard:

The brightness of signals received with this recorder and external input signals is adjusted automatically. This is normally the setting to use.

Mode 1:

This setting is used to record the signals darker when the screen is too bright.

Mode 2, 3, 4:

As the number rises, the signals are recorded brighter. Use these modes to adjust the brightness.

Audio input level

DVD-RAM DVD-RW DVD-R

Sets the audio input level of recorded sound.

Press the / buttons to select the desired item, and then press the / buttons to adjust the input level.

TV/Cable (L):

Sets the input level for the left channel.

(R):

Sets the input level for the right channel.

Line1, 2, 3 (L):

Sets the input level for the left channel of the external input connectors.

(R):

Sets the input level for the right channel of the external input connectors.

Introduction RecordingPlayback

Editing

Library Function setup Others

133