English -43

System Setup

42 -English

System Setup
Programme

Select “Tape Length”

Press the button to select the Tape Length.
This information is usually printed on the tape
box. The menu cycles through: E180, E240,
E280 or E300.
Once the type of cassette is set, the VCR can
display the amount of time remaining on the tape
when you press the DISPLAYbutton.
5
Select “VCR”
Using the buttons, move the selection bar
to“VCR”, then press or OK to select.
4
NICAM
AV 1 Output : RGB
: On
Programme
Programme

Select “Auto Repeat”

Move the selection bar to “ Auto Repeat”. It sets
the VCR to play a tape repeatedly [unless a tape
control is activated (Stop, Fast Forward or
Rewind).
7
Programme

Select “Auto Play”

Move the selection bar to “Auto Play,” then press
button to select from the following options:
• On - The VCR will automatically begin playing a
video tape when it is inserted, as long as
the safety tab of the cassette has been
removed.
• Off - Auto play is disabled.
6
VCR Setting
If you want your VHS Video tapes to play automatically
when you insert them, turn on Auto Play.
Select “System”
Use the buttons to highlight “System” then
press the OK button.
3
Programme
Only tapes that are missing the Record Safety
Tab will play automatically when inserted.
Note
Select Change Password using buttons,
then press the or OK button.
• The ‘Enter the password.’message will be
displayed.
1
Enter the 4-digit password using the 0 to 9 but-
tons on the remote control.
• The ‘Confirm the password.’message will be
displayed.
2
Enter your password again using the 0 to 9 but-
tons on the remote control.
3

About the Change Password;

Press the RETURN or ¥button to return to
the previous menu. Press the MENU button to
exit the menu.
Note
Open “MENU”
With the VCR in stop mode, Press the MENU
button.
1
Select “Setup”
Using the buttons, move the selection bar
to“Setup” then press or OK button to select.
2