Toshiba DVR620KC To stop the timer recording in progress, Select “Yes”, then press ENTER

TIMER RECORDING

To stop the timer recording in progress

1)Press [STOP C] on the remote control.

Confirmation message will appear.

2)Select “Yes”, then press [ENTER].

•To stop the timer recording immediately, press [STOP C] on the unit.

Checking, canceling, or correcting the timer programming information

1)Press [TIMER SET].

2) Press [TIMER PROG.].

3) Check the information on the list you want to edit.

Timer Programming

JAN/ 6/11 1:00 AM L1 SP
SP (1:00)		THU JAN/06 10:00AM
Date	Start	End	L1/L2
JAN/06	1:00AM	2:00AM	L1
	New Program
			1/1

4-A) To delete the timer program:

1 Use [K / L] to select the program you want to delete, then press [ENTER].

2 Use [K / L] to select “Delete”, then press [ENTER].

Selection menu will appear.

3 Use [K / L] to select “Yes”, then press [ENTER].

4-B) To correct the timer program:

1 Use [K / L] to select the program you want to correct, then press [ENTER].

2 Use [K / L] to select “Program Change”, then press [ENTER].

3 Correct the timer program by using [K/ L/ {/ B], then press [ENTER].

5)Press [TIMER PROG.] to exit.

6)Press [TIMER SET] to return to the timer standby mode.

If the timer program did not complete correctly, the error number appears in the timer programming list.

			Timer Programming
							THU JAN/06 10:00AM
				Date	Start		End	L1/L2
		E41 JAN/06			1:00AM	2:00AM		L1
					New Program
								1/1
Each error number means:
E1-22	Recording error other					E40		Some portion has
E37-39	than below							not been recorded
								because of program
E23-24	Unrecordable disc							overlapping.
								Recording did not
E25-28	Copy prohibited program
								start at the start time.
E29	Disc protected					E41		Power failed
E30	Disc full					E42		No disc when recording
E31-32	Already 99 titles					E43		Already 49 titles
	recorded							recorded
E33	Already 999 chapters					E44		Already 254 chapters
	recorded							recorded
E34	No space for Control					E45		Copy prohibited
	information							program
E35	PCA full *1					E46		It is impossible to
								record additionally
E36	Already finalized							on a disc recorded
								by other units
	video format disc
								when setting
								“Make Recording
								Compatible” to “OFF”.

•A program with the error number is grayed in the timer programming list.

•Once the timer programming list with error line(s) is displayed, or after canceling and setting again the timer standby mode, the program line(s) with error will be cleared.

*1 PCA is a disc's space reserved for recording test.

Disc Introduction Connections Basic Setup Management Recording Playback Editing Function Setup

Note

•Press [TIMER PROG.] to check the timer recording in progress.

When the timer recording is proceeding, that program will be highlighted in red. In this case, you cannot select any other program.

EN 41

VCR Function Others