E6580772③
3.1.2 Setting of communication parameters
To enable F10M communication, set following parameters to the inverter. The parameters will be validated by rebooting a power supply or changing a reset setting (f899) to1.
When interrupting a transmission to change the setting of command input, reboot a power supply if necessary, since the data which have been received before the interruption of transmission are stored in the inverter.
cmod Operation command mode selection
(Set this parameter to 4 to carry out run/stop with F10M communication.)
fmod Speed setting mode selection
(Set this parameter to 9 to execute frequency command with F10M communication.)
f802 Inverter number
f830 Data type selection
f831 Input reference setting 1
f832 Input reference setting 2
f833 Input reference setting 3
f834 Input reference setting 4
f835 Input reference setting 5
f836 Input reference setting 6
f841 Monitor output setting 1
f842 Monitor output setting 2
f843 Monitor output setting 3
f844 Monitor output setting 4
f845 Monitor output setting 5
f846 Monitor output setting 6
f850 Communication error selection
f851 Communication error detecting time
f899 Reset function (1 to reset)
11
