Toshiba FS-1450-1 SERIES owner manual Condition, Mode Lock SET

EO1-11097

STORE NAME/MESSAGE AND COMMERCIAL MESSAGE PROGRAMMING (Submode 1)

CONDITION	Any time outside a sale
OPERATION	Mode Lock: SET

1 [X]

....

Line No. [ST]

....

1 to 4:

Repeat for another line.

(For sequentially programming lines, the line

Submode No.

or

(See NOTE 2

number specification can be

5 to 7: below.)

Character Entries

max. 24 characters/line

(See CHARACTER ENTRIES at the beginning of this chapter.)

skipped.)

[ST]		[AT/TL]
....	....
To complete this line		To complete this
		programming
		operation

NOTES: 1. For each line, a maximum of 24 regular-size characters or 12 double-sized characters may be entered. A combination of both types is also available.

2.Even if the option “Store Name Print by RUBBER STAMP” is selected, data can be programmed for the store name/message. However, the Rubber Stamp, instead of the programmed name/message will actually be printed for operations to issue receipts.

If the option “Store Name Print by DOT PRINTER” is selected, use 1 through 4 for the store name/message and 5 through 7 for the commercial message data, as Line No.

The range Line Nos. 5 to 7 is unavailable to a manual-cut printer.

3.If no commercial message is required on the receipt, program blanks for all three lines. As a result no extra lines will be fed. If any one of the three lines is programmed, the two other lines will cause line feeds.

4.The 4-line range assigned for the store name/message will be either printed or fed, regardless of any system option selection.

5.If any incorrect characters have been programmed, depress the [C] key to clear all the characters on a line and then re-enter characters from the beginning, or end the line with an [ST] and re-program the entire line. The new data will be active.

6.When all the lines have been programmed, do a check by issuing receipt. Only the lines with errors need to be re-programmed; other lines will not be affected.

– 34 –