Toshiba FS-1450-1 SERIES PLU PRESET-CODE KEY Setting Submode, 27 @/FOR, Required key

EO1-11097

PLU PRESET-CODE KEY SETTING (Submode 27)

When there are any keys programmed as PLU Preset-code Keys on the ECR Keyboard, and/or when the PLU Keyboard PK-2 (hardware option) is connected to the ECR, a PLU code may be preset to each of those keys in this operation.

CONDITION	Any time outside a sale
OPERATION	Mode Lock: SET
	Repeat for other keys.

27 [@/FOR] Keyboard phase No. [ST] PLU Code [KEY]

[AT/TL]

1 to 3;

See NOTE 4 below

Enter through Numeric Keys on the ECR Keyboard

(Enter 0 to close the key); Max. 6 digits

Depress the required key on the ECR Keyboard or on the PK-2 Keyboard.

NOTES: 1. If the PLU Code entry is skipped and a [KEY] is simply depressed in the above sequence, the preprogrammed PLU Code of the KEY will be displayed.

2.A non-opened PLU Code (i.e. PLU non-existent in the PLU table file can be set on a KEY, however, pressing the KEY in sale entries will result in an error unless the code is opened in the PLU TABLE PROGRAMMING operation. Submode 4.

3.If “0” is entered as PLU Code in the above sequence, the KEY will be closed. Press- ing the closed KEY in sale entry will cause an error.

4.The designation of the keyboard phase No. is omissible. In this case, the PLU code is automatically programmed on the keyboard phase No. 1.

This designation is unavailable to the PK-2.

ex.) To set the following PLU Codes to KEYS on the ECR keyboard:

PLU Code	Mode Lock to SET.
	27 [@/FOR]
50321	50321 [required key]
	50322 [required key]
50322
	[AT/TL]

Location Code (left side): refer to REMARKS 1 and 2 on the next page.

PLU Code assigned to the key (right side)

TEC STORE

1343 PEACH DRIVE

PHONE : 87-6437

Open 8:00am to 7:00pm Closed : every Wednesday

12-19-1994 MON #1

	P 2 7
#073	050321
#074	050322
	0017

– 50 –