Toshiba GN-1060

1.SETTING UP WIRELESS NETWORK

Setting Up the Infrastructure Mode 25

1 SETTING UP WIRELESS NETWORK

Specify the following items and press [NEXT].

y TRANSMIT POWER

Select the low transmit power if you want to limit the area that the wireless communication is enabled. If you do not

have to limit the area, select [100%].

Confirm the settings and press [FINISH].

If you want to change the settings, press [PREV] to move back to the screen that you want to change and then

repeat the operation.

Press [YES], and wait until the setting is reflected.

Contents

Main Page Preface 1 Preface How to read this manual Symbols in this manual Model and series names in this manual Options Explanation for control panel and touch panel Trademarks Precautions 3 Precautions Precautions for Use About TOSHIBA Wireless Solution Wireless Interoperability Wireless LAN and your Health Regulatory Information Canada - Industry Canada (IC) Caution: Exposure to Radio Frequency Radiation. Europe - EU Declaration of Conformity EN 300 328: USA-Federal Communications Commission (FCC) Labelling Caution: Exposure to Radio Frequency Radiation. Page CONTENTS Chapter 1 SETTING UP WIRELESS NETWORK Chapter 2 APPENDIX Page Page 10 Before Setting Up Wireless Network Before Setting Up Wireless Network Planning for installation Determine the network type Infrastructure Mode Ad Hoc Mode Determine the SSID Determine the security mode WPA/WPA2/802.1X WPAPSK/WPA2PSK Page Setting Up the Infrastructure Mode Select network type Page Page 16 Setting Up the Infrastructure Mode Specify SSID Selecting the SSID from the available network list Press [AVAILABLE NETWORK]. Select the SSID that this equipment will connect and press [OK]. Page Page Setting Up the Infrastructure Mode 19 Select security mode Selecting WPA/WPA2/802.1X security mode with EAP-TLS protocol Press [WPA], [WPA2] or [802.1X], and then [NEXT]. Press [EAP-TLS] and press [NEXT]. Page Setting Up the Infrastructure Mode 21 Page Setting Up the Infrastructure Mode 23 Selecting WPA/WPA2/802.1X security mode with PEAP protocol Press [WPA], [WPA2] or [802.1X], and then [NEXT]. Press [PEAP] and press [NEXT]. 24 Setting Up the Infrastructure Mode Page 26 Setting Up the Infrastructure Mode Selecting WPAPSK/WPA2PSK security mode Press [WPAPSK] or [WPA2PSK] and press [NEXT]. Page 28 Setting Up the Infrastructure Mode Selecting WEP security mode Press [WEP] button and press [NEXT]. Page Page Page Setting up the Ad Hoc Mode Select network type Page Page Page Page Setting up the Ad Hoc Mode 37 Select security mode Selecting WEP security mode Press [WEP] and press [NEXT]. Page Page Page Page Page Page 44 Specification Specification Item Description Troubleshooting 45 Troubleshooting When Error Messages are Displayed When Cannot Connect to TOSHIBA MFP Glossary INDEX