1 SETTING UP WIRELESS NETWORK

„Select security mode

After specifying the SSID, you must select the security mode for your wireless network.

The procedure to configure the security mode varies depending on the security mode that you select. P.19 “Selecting WPA/WPA2/802.1X security mode with EAP-TLS protocol”

P.23 “Selecting WPA/WPA2/802.1X security mode with PEAP protocol”

P.26 “Selecting WPAPSK/WPA2PSK security mode”

P.28 “Selecting WEP security mode”

P.30 “Selecting no security mode”

If you are not sure what security mode to select, see the following section to determine the security mode. P.11 “Determine the security mode”

‰Selecting WPA/WPA2/802.1X security mode with EAP-TLS protocol

Using the WPA/WPA2/802.1X with the EAP-TLS protocol, you must install user certification file and CA certification file in the equipment. This equipment uses the user certification file to authenticate the access rights to the wireless network, and the RADIUS server authenticate this equipment using the CA certification file.

When using the WPA/WPA2/802.1X with the EAP-TLS protocol, you must install the CA certification file and user certification file in the equipment using TopAccess first. For instructions on how to install the CA certification and user certification files using TopAccess, refer to TopAccess Guide.

1 Press [WPA], [WPA2] or [802.1X], and then [NEXT].

The AUTHENTICATION SETTINGS screen is displayed.

To select [TKIP] or [AES (CCMP)], press [WPA] or [WPA2], or to select [DYNAMIC WEP], press [802.1X].

2 Press [EAP-TLS] and press [NEXT].

The WIRELESS AUTHENTICATION (EAP-TLS) screen is displayed.

Setting Up the Infrastructure Mode 19

Page 21
Image 21
Toshiba GN-1060 manual „ Select security mode, Press WPA, WPA2 or 802.1X, and then Next, Press EAP-TLS and press Next