CAUTION
•Be sure to refer to the wiring system diagram labeled inside the front panel.
•Check local electrical regulations for any specific wiring instructions or limitations.
Air inlet grille
FILE NO.
10-3-5. Piping and Drain Hose Installation
Piping and drain hose forming
•Since condensation results in machine trouble, make sure to insulate both the connecting pipes separately.
(Use polyethylene foam as insulating material.)
Rear right
Front panel
2 | 1 | 3 |
|
|
Fig.
Rear left
Bottom left
Left
Bottom right
Right
cutting |
| Changing drain | preparation |
panel slit |
| hose | Piping |
|
| ||
|
| ||
Die- Front |
|
| |
|
|
|
|
Lock nut | Conduit pipe |
| |
Inter connecting |
|
Fixing screw cable | Conduit mount |
Fig.
Cord clamp
Terminal cover | Terminal block | |
|
| |
Screw | L1 L2 | S |
L1 L2 S |
| |
| Ground line | |
Screw | Connecting cable | |
Screw | ||
Front panel |
|
|
Fig. |
| |
Ground | ||
line |
| |
13/16 in. (20 mm) |
| |
|
|
S
L2
L1
3/8 in. (10 mm)
Fig.
NOTE :
∙Use stranded wire only.
∙Wire type : minimum AWG14
Fig.
1.Die-cutting front panel slit
Cut out the slit on the left or right side of the front panel for the left or right connection and the slit on the bottom left or side of thefront panel for the bottom left or right connection with a pair of nippers.
2.Changing drain hose
For left connection,
How to remove the drain cap
Clip drain cap with
Fig.
How to remove the drain hose
The drain hose is secured in place by a screw.
Remove the screw securing the drain hose, then pull out the drain hose.
Screw | Drain hose |
|
Fig.
– 57 –