Toshiba SL-9000N-FFB CMT Operation Mode, LON System Mode, Error message, Bm/S, Message, Cause

16. ERROR MESSAGE TABLE

EM1-31064

16. ERROR MESSAGE TABLE

CMT Operation Mode

Message	Cause		Solution
	Mismatch of the model type.
MISMATCH SCALE	Mismatch of the base unit.
	Mismatch of the VERSION.	Press the	CLEAR	key.
SPEC
	Mismatch of the TRANS-
	MITTING DATA.
	Mismatch of the scale
	capacity.
	Parity error
	Framing error
	Overrun error
BAD TAPE OR CMT		Press the	CLEAR	key.
	Data error
	Two or More Hardware error
TIME OUT ERROR	Time out error	Press the	CLEAR	key.
LON System Mode

Error message			Cause		Solution	M	BM/S
COMMUNICA-	1.	The power of the master or backup		1.	Turn the power of the master
TION ERROR		master scale is not turned ON.			or backup master scale ON.
		They are not connected with each			Connect them with each other
		other or in off-line state.			or turn the scale in-line.
	2.	LON cable is broken.		2.	Call your authorized service
					representative.
SEQUENCE	The power was not turned OFF and			Turn the power switch OFF and
ERROR	ON again after setting ID #.			ON again.
SEQUENCE #	Text data number is incorrect.			Call your authorized service
ERROR				representative.
MASTER BUSY	Registration job is performed on a			1.	Quit reset job on the master
	satellite scale while reset job is per-				scale.
	formed on the master scale.			2.	Quit registration job on the
					satellite scale.
BACKUP MAS-	The backup master does not have the			Down load PLU from the master
TER NOT RESET	same PLU with the mater scale.			to the backup master scale.
				Then run the reset operation
				again.
TEXT ERROR ##	1.	Error text is found.		Call the TOSHIBA TEC autho-
		02:	Sequence No. error	rized service representative.
		05:	LRC error
		08:	Text error
		09: Command error
	2. The master scale differs from other
		scale in ROM version.

M: Master scale BM: Backup master scale S: Satellite scale

16-3