Toshiba SL-9000-FFB, SL-9000N-FFB, EM1-31064JE owner manual Cleaning The Print Head

17. CLEANING THE PRINT HEAD

EM1-31064

17. CLEANING THE PRINT HEAD

17. CLEANING THE PRINT HEAD

WARNING!

Since there is a cutter at the paper outlet, be careful not to injure your fingers when cleaning the print head and cutter.

If the print head is dirty, printing will not be clear. The print head should be cleaned with a print head cleaner everyday before use, according to the following procedure:

1.Open the label cover and remove the label cassette. (See page 9-1)

2.Clean the print head element with the print head cleaner.

Print Head

Print Head Cleaner

Element

3.Clean the print head element with the print head cleaner. NOTE: Be careful not to damage the print head when cleaning.

4.If any label paste is found on the cutter, wipe off the paste with alcohol.

After removing the label cutter, reattach it using the following procedure.

1.Install an unloaded label cassette on the scale.

2.Install the label cutter, aligning the cutter notches with the screw holes.

3.Secure the cutter with the screw (FL-3x6) so the bottom of the cutter is 0.5~0.8 mm above the peel-off plate.

Head Holder

Screw (FL-3x6)

Screw (FL-3x6)

Clearance 0.5~0.8 mm

Peel-off Plate Label Cutter

Label Cutter

NOTE: If the cutter is scratching labels during printing, increase the clearance between the cutter and peel-off plate.

17-1