12 Strata CTX Standard Telephone User Guide October 2002
Call Forward
Advanced Operati on
Call Forward Procedures
The following table contains Call Forward Button sequences. You can do a Call Forward function by
one, entering the button sequence as described, or two, programming a flexible button to perform the
sequence. See “Call Forward Procedure” on page 12 for instructions on programming a flexible
button.
Some Call Forward features require a Pass Code entry. Use the following procedure to change your
Pass Code.
➤To change your Pass Cod e
➤Lift the handset, press + ext. no. + old Pass Code (1~15 digits) + + new Pass Code (1~15
digits) + .
➤To use the Call Forward button sequence
➤Follow the instructions in the following table, shown under “Button Sequence.” Some features
require additional input, such as:
♦Destination – If the destination is an outside number, press after entering the destination.
The CTX accepts destination numbers of up to 32 digits.
♦Timer – This is a two digit entry representing how long (8 to 60 seconds) your te l ep h o n e
should ring before forwarding the call. If you enter one digit, you must press after entering
the single digit.
♦Pass Code – A four-digit code established by syst em progra mming to prevent unauthorised
changes. The code applies to the station to be forwarded; not to the station entering the code.
Note In the following table, (Tone) means that a confirmation tone will play at that point in the
sequence.
Table 1 Call Forward Procedure
Feature Button Sequence
Call Forward Any Call (Internal and Incoming Line)
All Calls Lift handset, press (Tone) + Destination No. + (Tone)
Busy Lift handset, press (Tone) + Dest. No. + (Tone)
No Answer Lift handset, press (Tone) + Dest. No. + (Tone) + Timer +
Busy No Answer Lift handset, press + Dest. No. + + Timer +
Cancel Lift handset, press (Tone)