4.5 HDD 4 Replacement Procedures
4.5 HDD Removing the HDD
The following describes the procedure for removing the HDD. (See Figure 4-5 and 4-6.)
Caution: Take care not to press on the top or bottom of the HDD. Pressure may cause
data loss or damage to the device.
1. Turn the computer upside down.
2. Loosen the screw (with e-ring) fixing the HDD slot cover and remove the HDD slot
cover.
3. Pull out the HDD assembly from the connector CN1900 of HDD cable.
Note: When removing the HDD assembly, be careful not to tear the laminate. If the
laminate is torn, replace it with a new one.
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-15
Figure 4-5 Removing the HDD FPC
HDD slot cover Screw (with e-ring)
HDD assembly
CN1900