4 Replacement Procedures 4.15 DC-IN jack
4.15 DC-IN jack Removing the DC-IN jack
The following describes the procedure for removing the DC-IN jack. (See Figure 4-24.)
1. Pull up the DC-IN jack straight from the slot of cover assembly.
2. Disconnect the DC-IN jack from the connector CN8800 on the system board
DC-IN jack
CN8800
Figure 4-24 Removing the DC-IN jack
Installing the DC-IN jack
The following describes the procedure for installing the DC-IN jack. (See Figure 4-24.)
1. Connect the DC-IN jack to the connector CN8800 on the system board.
2. Install the DC-IN jack by fitting guide of slot of cover assembly.
4-40 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)